Blendtec Q-SERIES Manuel d'utilisateur télécharger pdf (Page 6)

• The Blender Q-Series products can be easily assembled or dismantled by

anyone.

(You can assemble or dismantle the products without using any special tool.)

• Visit our Internet homepage (http://aspenkorea.com) in regard to the user’s

manual for assembling or dismantling the products. www.aspnekorea.com

4. INSTALLATION & CAUTIONS

41. INSTALLATION ON THE COUNTER (A Stand Type)

• Use the power outlet within 1.2m. (Use one power outlet per one blender.)

• Install the blender on the ﬂat and dry place.

• Avoid a wet place when installing the blender. (For example, avoid the place

next to the sink. Install the blender on the open place to avoid sealing off the

vent of the blender.)

42. INSTALLATION ON THE SHELF (An In-Counter Type) (Refer to the

pictures on Page 15 and Page 16.)

• The thickness of the upper part of the shelf must be less than 19mm. (When

the thickness of the upper part of the shelf is more than 19mm, the vent of

the motor can be sealed off.)

• When installing more than two blenders, the distance between the centers of

the blenders must be between 356mm and 406mm.

• Use the power outlet within the distance of 1.2m. (When installing the

blender, use one power outlet for one blender.)

• Install the blender on the ﬂat and dry place.

• Avoid a wet place when installing the blender. (For example, avoid the place

next to the sink.)

5 - Noise-Preventing Case Cover

3 - Noise-Preventing Case

1 - Built-in Noise-Absorbing Case

6 - Lower Case Cover

7 - Motor

4 - Jar

2 - Lower Case

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Pas de commentaire

Blendtec Q-SERIES Manuel d'utilisateur Page 6